Installation and use of intelligent induction parking lock

1 installation location

 Select the cement floor outside, flat and dry, will be placed in the middle of the parking space lock entrance, so that the normal car into the parking space will not be crushed to the lock.

2 installation method

First of all, pull up the lock block arm to an upright position, and then use the key to open the lock on the upper cover, lift the upper cover. According to the position of the three mounting holes on the floor feet of the parking lock, drill three holes with diameter of 12mm and depth of 50mm, and insert the expansion bolt of M8. First, 3 pieces of equipped gasket set on the bolt, and then installed on the parking lock, install and tighten the nut. Place the battery in a specific location of the parking lock, take the corresponding vehicle identification card to a distance (40m away if empty) , then plug the battery into the corresponding Jack and cover the parking lock cover, then lock the top cover and clip the antenna into the antenna holder. Take the corresponding vehicle identification card near the parking lock and put the parking lock block arm down, indicating that the parking lock is installed successfully. The vehicle identification card should preferably be attached to the back of the vehicle’s rear view mirror or the middle of the upper edge of the front windshield.

3 method of use

 The vehicle identification card is installed on a specific vehicle. When the vehicle approaches the parking lock, the stop arm of the parking lock drops, and when the vehicle moves away from the parking lock, the parking lock is raised. Pay attention to intelligent sensor parking lock, parking lock in the process of use should always clean its surface dust and garbage, try to ensure that the parking lock clean, dry. Try to ensure that the antenna card in the antenna seat, vertical direction upward, so as not to affect the normal work of the parking lock. Before using the Parking Space Lock, the battery should be recharged, the charging time should be controlled in more than 10 hours, the indicator light of the Charger will change from red to green after charging. In the use of the car when the sound of the alarm or found that the block arm running obviously slow should be recharged in time. When the vehicle identification card within one minute a green light does not flash means that the vehicle identification card power, the Vehicle Identification Card charge.